Impala V6-3.8L SC VIN 1 (2005)
44. Twist together 2 connector wire leads, the low circuits from both stages of the I/P module, to the deployment harness wire. Refer to SIR Connector
End Views in order to determine the correct circuits.
45. Inspect that the 3 wire connection is secure.
46. Bend flat the twisted connection.
47. Secure and insulate the 3 wire connection to the deployment harness using electrical tape.
48. Connect the deployment harness to the I/P module connector.
49. Route the deployment harness out of the passenger side of the vehicle.
50. Completely cover the windshield and the front door openings with a drop cloth.
51. Stretch out all of the deployment harness wires on the left and right side of the vehicle to their full length.
52. Deploy each deployment loop one at a time.
53. Place a power source, 12 V minimum/2 A minimum, i.e., a vehicle battery, near the shorted end of the harnesses.
54. Separate one set of wires and touch the wire ends to the power source in order to deploy the inflator modules, doing only one inflator module at a