Impala V6-3.8L SC VIN 1 (2005)
Positive: Service and Repair
BATTERY POSITIVE CABLE REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
IMPORTANT: When replacing battery cables be sure to use replacement cables that are the same type, gage and length.
2. Disconnect the positive battery cable.
3. Remove the ground wire bolt and the ground wire from the frame.
4. Remove the remote positive stud cover
5. Remove the positive cable junction block lead nut (1).
6. Remove the positive battery cable (2) from the underhood accessory wiring junction block.
7. Raise and support the vehicle. Refer to Vehicle Lifting.
8. Remove the front lower air deflector.
9. Remove the transaxle stud nut and the ground wire from the transaxle stud.
10. Remove the positive battery cable nut (8) from the starter motor BAT terminal.
11. Remove the positive battery cable (9) from the starter motor BAT terminal.