Impala V6-3.8L SC VIN 1 (2005)
12. Unclip and remove the battery cable harness from the retainers (2,3,4).
13. Remove the battery cable harness from the vehicle.
14. Remove the positive battery cable from the wiring harness conduit.
INSTALLATION PROCEDURE
1. Install the positive battery cable into the wiring harness conduit.
2. Install the battery cable harness to the retainers (2,3,4).
3. Install the positive battery cable (9) to the starter motor BAT terminal.
4. Install the positive battery cable nut (8) to the starter motor BAT terminal.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 10 N.m (89 lb in).
5. Install the ground wire and the transaxle stud nut.
Tighten the nut to 25 N.m (18 lb ft).
6. Install the front lower air deflector.
7. Lower the vehicle.
8. Install the positive battery cable (2) to the underhood accessory wiring junction block.
9. Install the positive cable junction block lead nut (1).