Impala V8-5.3L (2008)
Parking Brake Lever: Service and Repair
Parking Brake Lever Pedal Assembly Replacement
Tools Required
J 37043 Parking Brake Cable Release Tool
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Relieve the cable tension at the park brake equalizer.
3. Disconnect the front cable from the connector (2).
4. Lower the vehicle.
5. Remove the left side closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
6. Remove the left side front carpet retainers. Refer to Center Pillar Lower Trim Panel Replacement .
7. Disconnect the electrical connector at the park brake switch.
8. Remove the 3 park brake pedal assembly retraining nuts from the body mounting studs.
