Impala V8-5.3L (2008)
9. Remove the retaining clip and disconnect the cable button from the clevis.
10. Use the J 37043 to release and remove cable from the bracket on the pedal assembly.
11. Remove the park brake pedal assembly.
Installation Procedure
1. Install the park brake assembly onto the body mounting studs.
Notice: Refer to Fastener Notice .
2. Install the 3 park brake pedal assembly retaining nuts.
Tighten the nuts to 25 N.m (18 lb ft).
3. Install the front park brake cable into the bracket on the park brake pedal assembly.
4. Insert the cable button into the clevis and install the retaining clip.
5. Connect the electrical connector to the park brake switch.
6. Reposition the carpeting properly.
7. Install the left side carpet retainers and the lower center pillar trim panel on the left side. Refer to Center Pillar Lower Trim Panel Replacement .
8. Install the left side closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
9. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
10. Install the front park brake cable through the park brake cable guides.
