Lumina V6-3.1L VIN J (2000)
Axle Shaft Assembly: Service and Repair
Wheel Drive Shafts Replacement
Removal Procedure
^
Tools Required
-
J2619-01 Slide Hammer
-
J28733-B Front Hub Spindle Remover
-
J29794 Extension
-
J33008 Axle Shaft Remover
Notice: When servicing the hub assembly, be careful not to damage the ABS components. If any of the ABS components are damaged, the ABS
system may not function properly and the damaged component will need to be replaced.
The ABS exciter ring is shown.
Important: Prevent the boots (seals) from contacting the other components in order to prevent damage to the boots (seals).
1. Remove the wheel cover or hub cap.
2. Remove the front wheel drive shaft nut (1).
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
4. Remove the tire and the wheel.
5. Remove the brake caliper/bracket and rotor.
6. Disconnect the front wheel speed sensor connector and remove the front wheel drive shaft bearing. Refer to Front Wheel Drive Shaft Bearing
Replacement in Steering and Suspension.
Caution: Do not attempt to move vehicle with drive axle(s) removed from wheel bearing. Wheel(s) could fall off, dropping vehicle to the
ground and causing personal injury or damage to the vehicle.