Malibu L4-2.4L (2010)
Parking Lock Cable: Adjustments
6T70/6T75 - Automatic Transmission
Park Lock Cable Adjustment
1. Place the floor shift lever in the PARK position.
2. Turn the ignition key cylinder to the LOCK position.
3. If the front floor console is in place, remove the console. Refer to Front Floor Console Replacement (See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair/Front Floor Console Replacement).
Important:
*
The key must not be able to be removed from the ignition cylinder with the transmission control lever in any position other than
PARK. If they key can be removed in any other position, adjustment or repair is necessary.
*
The shift lever must not move from park unless the key is in the ON position. If the lever can be removed from park with the key in
the OFF position, adjust or repair the park lock cable.
4. While using a small screwdriver to release the adjuster lock tang, rotate the threaded cable adjuster (1) until 3 threads are showing.
5. Re-check park lock operation. If park lock does not function, fine tune the cable 1/2 turn at a time until the proper operation is achieved.
