Malibu L4-2.4L (2010)
Important: Ensure the ignition key is in the RUN position. Do NOT attempt to remove the park lock cable with the key in any other
position.
8. Using a screwdriver, release the cable from the ignition switch inhibitor by depressing the cable latch (1).
9. Remove the park lock cable from the inhibitor housing.
10. Attach a long piece of mechanics wire to the end of the park lock cable before removing the cable. The wire will assist with installation of the new
cable.
11. Remove the park lock cable from the vehicle.
12. Remove the mechanics wire from the park lock cable.
Installation Procedure
1. Attach the mechanics wire to the park lock cable in order to assist with installation of the cable.
2. Install the park lock cable to the vehicle.
3. Remove the mechanics wire from the park lock cable.
4. Ensure the shift lever is in the PARK position.
5. Ensure that the ignition key is in the RUN position.
