Metro L3-061 1.0L VIN 6 TBI (1998)
^
ABS hydraulic modulator (4)
^
Front brake hose fitting pipe
4. Raise and support the vehicle.
5. Remove the pipe(s) from the guide brackets.
6. Remove the pipes from the vehicle.
INSTALLATION PROCEDURE
1. Install the pipe(s) to the front wheel brake hose fitting.
2. Lower the vehicle.
3. Install the new pipe(s) to the following locations (where applicable):
^
ABS hydraulic modulator
^
Master cylinder ABS hydraulic modulator
^
Proportioning valve
NOTICE: Refer to Service Precautions.
4. Secure the pipe(s) with guide brackets and pipe fitting nuts.
^
Tighten the brake pipe fitting nuts to 16 Nm (12 ft. lbs.).
5. Flush the brake system.