Metro L3-061 1.0L VIN 6 TBI (1998)
^
Excessive wear
^
Damage
INSTALLATION PROCEDURE
1. Apply lithium grease to the clutch cable clevis (1).
2. Install the clutch cable (2) through the bulkhead from the engine compartment side.
3. Install the clutch cable clevis (1) to the clutch pedal lever.
4. Install the 2 clutch cable grommet bolts (3) to the bulkhead (1).
^
Tighten the clutch cable grommet bolts (2) to 6 Nm (53 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Install the clutch cable (2) through the clutch cable bracket (3).
6. Install the clutch cable through the clutch release lever (4). Secure the clutch cable, with the clutch cable adjustment nut (5).
7. Measure the clutch release lever (4) free travel.
Free travel specification for the clutch pedal is 15 - 20 mm (0.6 - 0.8 inch).
8. Adjust the clutch pedal free travel. Tighten or loosen the clutch cable adjustment nut (5) until the clutch pedal free travel is within specifications.
