Metro L3-061 1.0L VIN 6 TBI (1998)
11. Install the fifth and reverse gearshift cam onto the gearshift and select shaft.
12. Install the reverse interlock shaft roll pin into the gearshift and select shaft using a standard drift punch and a hammer.
13. Install the following items into the left case:
^
The gearshift and select shaft assembly (1)
^
The gearshift interlock bolt (2) and washer
^
Tighten the gearshift interlock bolt to 28 Nm (21 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
14. Raise and suitably support the vehicle.
15. Align the gearshift and select shaft assembly bolt hole with the gearshift yoke bolt hole.
16. Apply GM P/N 12345493, or equivalent, to the threaded portion of the gearshift yoke bolt hole.
17. Install the gearshift yoke bolt (2) into the gearshift yoke (3).
^
Tighten the gearshift yoke bolt to 28 Nm (21 ft. lbs.).