Monte Carlo V6-3.8L SC VIN 1 (2004)
Notice: Refer to Fastener Notice in Service Precautions.
11. Install the nuts to the interface module bracket.
Tighten the nuts to 4 N.m (35 lb in).
12. Install the plastic cover on the On-Star module.
13. Install the convenience net and retainers, if equipped.
14. Install the tail lamp retainers.
15. If equipped, install the sill plate. Refer to Compartment Sill Plate Replacement - Rear.
16. If the vehicle is not equipped with a sill plate, install the push-in retainers beside the lock striker.
17. Close the rear compartment.
Garnish Molding Replacement
GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR (MONTE CARLO)
REMOVAL PROCEDURE
1. Reposition the rear upper quarter trim panel.
2. Remove the windshield garnish molding from the clip retainers on the upper/roof side rail.
