Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
NOTICE: Refer to Fastener Notice in Service Precautions.
1. Install the following components to the bulkhead:
^
A new gasket (11) between the booster assembly (9) and the bulkhead
^
The booster assembly (9)
^
Secure the four booster assembly mounting nuts (7,8,12,13).
^
Tighten the booster assembly mounting nuts to 13Nm (115 in. lbs.).
2. Install the clevis (3) to the operating rod.
3. Install the following components to the clevis (3):
^
The wave washer (2)
^
The clevis pin (1)
^
The cotter pin (4)
4. Install the brake pedal return spring (6).
5. If the vehicle is equipped with ABS, install the following components to the booster assembly (5):
5.1. The gasket (2)
5.2. The bracket for the brake pressure modulator valve assembly (3)
5.3. Three nuts. Tighten the nuts by hand.
6. Install a new gasket on the master cylinder.
