Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
7. Place the J 39567 on the gasket.
8. Lower the J 39567 pin down until the pin touches the master cylinder piston (2).
9. Remove the J 39567 from the master cylinder.
10. Turn the J 39567 upside down.
11. If the vehicle is equipped with ABS, place the J 39567 on the bracket for the brake pressure modulator valve assembly.
12. If the vehicle is not equipped with ABS, place the J 39567 on the booster assembly (1).
13. Measure the clearance (2) between the booster piston rod (3) and the J 39567. Ensure that the clearance is O mm (O in).
14. If the booster piston rod length is not within specifications, complete the following procedure:
14.1. Ask an assistant to push the booster piston rod out by pressing the brake pedal.
14.2. Turn the booster piston rod until the booster piston rod slightly touches the pin head.
