Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
6. Install one bolt (1) to the exhaust manifold support bracket.
^
Tighten the exhaust manifold bracket bolt to 32 Nm (24 ft. lbs.).
7. Install the front exhaust pipe to the manifold flange.
Use the following components in order to secure the front exhaust pipe.
^
Two bolts
^
Two springs
^
Tighten the front exhaust pipe bolts to 62 Nm (46 ft. lbs.).
8. Install the following components to the front exhaust pipe:
^
The new oxygen sensor gasket
^
The oxygen sensor
9. Secure the heated oxygen sensor using two nuts.
^
Tighten the heated oxygen sensor nuts to 41 Nm (30 ft. lbs.).
10. Connect the (HO2S1) electrical connector.
11. Connect the negative battery cable.
