Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
7. Remove the electrical connector (2) from the shift lock control module (1).
8. Remove the shift lock control module from the manual selector.
INSTALLATION PROCEDURE
1. Install the shift lock control module (1) to the manual selector.
2. Install the electrical connector (2) to the shift lock control module.
3. Install the shift lock solenoid and the shift lock switch assembly electrical connectors (2,3) to the shift lock solenoid.
IMPORTANT: Upon the completion of the shift lock control module installation, perform the following steps in order to ensure proper
operation:
^
Temporarily install the negative (-) battery cable.
^
When the ignition switch is turned to LOCK, the solenoid is NOT energized.