Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
1. Install the inner joint seal using a press.
2. If the damper was removed, install the damper to the wheel drive shaft before installing the inner joint.
3. Install the damper assembly (right side wheel drive shaft only) to the wheel drive shaft.
4. The damper should be located on the groove on the wheel drive shaft.
5. The damper centerline should be 431.3 mm (16.980 inch), plus or minus 3.0 mm (0.118 inch) from the outer joint. Crimp the damper clamp using
the J 22610.
6. Install the inner joint housing boot (2) and clamps (3) to the wheel drive shaft. Do not crimp the clamps at this time.
