Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
^
J 35399
^
J 8092
^
A press
10. Install the front wheel bearing retainer to the steering knuckle using snap ring pliers.
11. Install the inner seal to the steering knuckle using the J 35737-02.
12. Apply GCLB grease (or equivalent) to the inner seal lip.
Important: If the vehicle is equipped with ABS, align the holes for the ABS speed sensor in the inner shield and the steering knuckle.
13. Install the inner seal shield to the steering knuckle.
14. If installing the wheel hub, bearing, and seal to a new steering knuckle, install the ball stud. Refer to STEERING KNUCKLE REPLACEMENT.
15. If installing the wheel hub, bearing, and seal to the steering knuckle with the ball stud attached, remove the steering knuckle from the vise.
16. Install the steering knuckle with the ball stud to the vehicle. Refer to STEERING KNUCKLE REPLACEMENT.
17. Install the brake rotor to the vehicle. Refer to BRAKE ROTOR REPLACEMENT in DISC BRAKES.
18. Install the brake caliper bracket to the vehicle. Refer to BRAKE CALIPER BRACKET REPLACEMENT in DISC BRAKES.
19. Install the following components to the strut:
^
The front brake hose
^
The one bolt
Tighten
Tighten the bolt to 29 Nm (22 ft. lbs.).
20. Install the ABS wheel speed sensor to the knuckle. Secure with one bolt.
Tighten
Tighten the bolt to 8 Nm (71 ft. lbs.).
21. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS.
22. Lower the vehicle.
23. Inspect the front wheel alignment. Refer to MEASURING WHEEL ALIGNMENT in WHEEL ALIGNMENT.
