S10/T10 Blazer 4WD V6-262 4.3L VIN W CPI (1992)
Use either a 50-50 mixture (by volume) of water and isopropyl alcohol; or flash naphtha may be used, or equivalent (procure locally).
3.
Use heat to dry the solvent on the affected sheet metal.
The sheet metal temperature should be 80 degrees F. (27 degrees C) or 10 degrees F. (6 degrees C) above the air temperature in the area,
whichever is higher.
The sheet metal temperature should NOT exceed 105 degrees F. (41 degrees C).
4.
Heat the weatherstrip seal to 75 to 80 degrees F. (24 to 27 degrees C) just prior to installation.
5.
Immediately prior to installation, remove the protective liner on the back of the warm seal. The adhesive surface MUST be kept clean and warm.
6.
Install a new WARMED weatherstrip seal (P/N 15700883-LH and 15700884-RH) (Figure 1, View A and Section B-B). Position the weatherstrip
seal to the roof panel with the tapered end of the seal to the rear. Press firmly on the seal using 3 to 10 lbs (13 to 44 N) of force to provide proper
adhesion.
7.
Check for proper seal to sheet metal adhesion. If any gaps between the seal and sheet metal exist, the seal must be removed and replaced with a
NEW seal following Steps 2 through 6.
8.
Check the door operation to insure no interference between the seal and door exists. THE SEAL SHOULD NOT CONTACT THE DOOR SHEET
METAL. If contact exists, repeat Steps 1 through 7 using a NEW seal.
SERVICE PARTS INFORMATION
Isopropyl alcohol or flash naphtha may be procured locally.
Parts are currently available from GMSPO.
WARRANTY INFORMATION For vehicles repaired under warranty use:
