S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
A. Place a brass drift against the cage. Tap gently on the brass drift in order to tilt the cage. Remove the first ball when the cage tilts.
B. Repeat step A. to remove all of the balls.
C. Pivot the cage and the inner race 90° to the center line of the outer race. At the same time, align the cage windows with the lands of the outer
race. Lift out the cage and the inner race.
D. Remove the inner race from the cage by rotating the inner race upward.
E. Thoroughly degrease all of the CV joint parts.
6. Check the outer CV joint assembly for unusual wear, cracks, or other damage. Replace any damaged parts.
7. Clean the axle shaft. Use a wire brush to remove any rust in the seal mounting area (grooves).
Disassemble Tripot Joint and Seal
-
Tools Required:
-
J 8059 Snap Ring Pliers
-
J 35910 Seal Clamp Tool
