S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
7. Slide the CV joint onto the axle shaft. The retaining snap ring inside of the inner race engages in the axle shaft groove with a "click" when the CV
joint is in the proper position. Pull on the CV joint to verify engagement.
8. Slide the large diameter of the CV joint seal, with the large retaining ring in place, over the outside edge of the CV joint outer race.
Position the lip of the CV joint seal into the groove on the CV joint outer race. Manipulate the CV joint seal to remove any excess air.
9. Secure the large retaining clamp (this replaces the swedge ring) and the seal to the housing with the tool J 35910 (or equivalent), a breaker bar, and
a torque wrench. Torque the large retaining clamp to 176 Nm (130 ft. lbs.). Check the gap dimension on the clamp ear.
10. Install the seal clamp protectors (if used) over the large retaining clamp.
