S10/T10 P/U 2WD V6-4.3L VIN W (1997)
Blower Motor Resistor: Service and Repair
Heater System
Blower Motor Resistor Without A/C
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Electrical connector.
3. Blower motor resistor screws.
4. Blower motor resistor.
INSTALL OR CONNECT
1. Blower motor resistor.
NOTICE: Refer to "Fasteners" under "Vehicle Damage Warnings."
2. Blower motor resistor screws.
-
Tighten screws to 1.9 Nm (17 lbs. in.).
3. Electrical connector.
4. Negative battery cable.
-
Perform "Heater Function Test."