S10/T10 P/U 2WD V6-4.3L VIN W (1997)
Window Regulator: Service and Repair
Window Regulator Handle
Window Regulator Handle
Tools Required:
J 9886-01 Door Handle Clip Remover
Remove or Disconnect
1. Raise the window to the closed position.
2. Window regulator handle from the door.
A. Insert tool J 9886-01 between the handle and the bearing plate.
B. Align the tool with the handle and push to disengage the clip.
C. Pull the handle from the door.
3. Bearing plate from the door.
Install or Connect
1. Bearing plate to the door.
2. Window regulator handle to the door.
A. Install the retaining clip to the handle.
B. Insert the handle onto the window regulator shaft so that the handle is pointing toward the front of the door.
C. Push on the handle until the clip engages on the shaft.