Silverado 1500 4WD V8-6.0L Hybrid (2009)
Note
The sight shield mounting fastener must be installed and tightened. Failure to properly tighten the sight shield mounting fastener may result in an open
High Voltage Interlock Circuit (HVIC) condition and DTCs.
1. Install the sight shield onto the ball studs (2) and tighten the sight shield mounting fastener (1). Tighten the fastener to 5 Nm (44 lb in) .
2. Install the fender brace. Refer to Front Fender Rear Upper Brace Replacement (See: Body and Frame/Fender/Front Fender/Service and Repair) .
3. Enable high voltage. Refer to High Voltage Enabling (See: Battery System, Hybrid Drive/Testing and Inspection/Initial Inspection and
Diagnostic Overview/High Voltage Enabling) .
