Silverado 2500 2WD V8-8.1L VIN G (2005)
1. Remove filter (4) by rotating it in the counterclockwise direction.
2. Remove the magnet (2) from the filter attachment tube (1) in the converter housing or from the filter element.
3. Clean any metal debris from the magnet. Presence of any metal pieces larger than dust may indicate that transmission replacement or overhaul is
required.
4. Remove the filter attachment tube (1) from the converter housing.
Installation Procedure
1. Install the filter attachment tube (1).
Notice: Refer to Fastener Notice in Service Precautions.
^
Tighten the attachment tube to 30 Nm (22 ft. lbs.).
2. Reinstall the magnet (2) onto the filter attachment tube (1).
3. Lubricate the gasket (3) on the control main filter with transmission fluid.
4. Install, by hand, the control main filter (4) until the gasket on the control main filter touches the converter housing.
5. Notice: Turning the control-main filter more than ONE FULL TURN after gasket contact will damage the filter and may cause fluid leakage.
Turn the filter ONE FULL TURN ONLY after gasket contact.
6. Notice: Use only clean and approved transmission fluid.
Check the transmission fluid level.
