Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
1. Remove the rear seat from the vehicle.
2. Remove the J-Clips from the back of the seat.
3. Remove the bolts (2) from the grab handle (1).
4. Remove the support rod (1) from the bottom of the seat.
5. Loosen the bolts (1) on the roller assembly (2) but do not remove.
6. Remove the seat cushion cover and pad from the seat frame.
INSTALLATION PROCEDURE
1. Install the seat cushion cover and pad to the seat frame.
NOTE: Refer to Fastener Notice in Service Precautions.
