Tahoe 2WD V8-6.0L Hybrid (2008)
1. Install new APM coolant seal (3).
2. Position the APM (2) onto the PIM ensuring the seals remain in place.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
3. Install the APM mounting fasteners (1).
Tighten the mounting fasteners to 10 N.m (89 lb in).
4. Rotate the drive motor generator control module assembly onto the APM.
5. Attach the GE-48494 components (2, 3, 4) to a coolant pipe.
6. Plug the remaining coolant pipe with the GE-48494 plug (1).
