Tracker 2WD L4-1.6L VIN 6 (2000)
12. Install the battery terminal retaining nut (2) to the rear housing.
Tighten
Tighten the battery terminal retaining nut to 10 N.m (89 lb in).
13. Install the rear bearing to the rotor.
14. Install the front bearing and the front bearing retainer to the front housing. Secure with 4 screws (1,3).
15. Install the rotor with the spacer to the front housing.
NOTE: To prevent damage to the rotor, place clean shop cloths between the rotor and the vise.
16. Place the front housing and the rotor into a vise, facing the drive pulley end up.
17. Install the drive pulley and the drive pulley washer to the rotor. Secure the pulley with the retaining nut.
