Tracker 2WD L4-1.6L VIN 6 (2000)
Tighten
Tighten the drive pulley retaining nut to 118 N.m (86 lb ft).
18. Remove the front housing and the rotor from the vise.
19. Using a heat gun, heat the rear housing to 50-60°C (122-140°F)
20. Align the generator housing match marks. Install the front housing (4), with the drive pulley and rotor, to the stator coil (5) and rear housing (6).
21. Install the 4 front housing generator housing bolts (1,3).
Tighten
Tighten the generator housing bolts to 17 N.m (10 lb ft).
22. Remove the brush support wire and install the hole plug into the rear housing.
23. Make sure that the rotor rotates smoothly by turning the drive pulley.
24. Install the generator to the vehicle.
