Tracker 2WD L4-2.0L VIN C (1999)
INSTALLATION PROCEDURE
1. Install the rear side window switch to the rear side door trim panel (2), if removed. Ensure that the 4 plastic retaining tabs are fully engaged.
2. Connect the rear side window switch electrical connector, if equipped.
3. Install the door trim panel (2) to the rear side door. Ensure that the plastic retainers are fully engaged.
4. Install the rear side door window regulator handle snap ring (1) to the rear side door window regulator handle (2), if equipped.
5. Install the window regulator handle (2) to the door, if equipped.
6. Install the screw which secures the rear side door pull handle (3).
7. Install the rear side door inside handle (1).