Tracker 2WD L4-2.0L VIN C (1999)
Engine Mount: Service and Repair
Engine Mount Replacement (Left)
Removal Procedure
1. Remove the nut from the top of the engine mount.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Support the engine using an engine support stand.
4. Remove the 2 nuts from the bottom of the engine mount.
5. Raise the engine slightly in order to provide clearance for the engine mount assembly removal.
6. Remove the left side engine mount (5).
7. Remove the 4 bolts and the engine block bracket (1) (if necessary).
8. Remove the 4 bolts and the body mount bracket (4) (if necessary).
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the body mount bracket (4) (if removed).
Tighten the 4 bolts to 85 Nm (62 ft. lbs.).
2. Install the engine block bracket (1) (if removed).
Tighten the 4 bolts to 50 Nm (37 ft. lbs.).
3. Install the left side engine mount (5).
4. Lower the engine.
5. Install the 2 left side engine mount nuts.
Tighten the 2 nuts to 50 Nm (37 ft. lbs.).
6. Lower the vehicle.
7. Install the upper engine mount nut.
Tighten the nut to 50 Nm (37 ft. lbs.).
