Tracker 2WD L4-2.0L VIN C (1999)
IMPORTANT: DO NOT tighten the stabilizer shaft link nuts and bolts completely. The weight of the vehicle must be on the wheels and tires
before tightening the nuts and bolts.
3. Install the following components in order to connect the stabilizer shaft link to the lower control arm:
-
The stabilizer shaft nut (1)
-
The washer (2)
-
The bushing (3)
4. Install the ball stud (5) to the knuckle (1).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Install a new ball stud nut (2).
-
Tighten the ball stud nut to 60 Nm (43.5 ft. lbs.).
6. Install the tire and wheel assembly.
7. Lower the vehicle.
8. Ensure the stabilizer shaft is centered, side-to-side. Verify that the stabilizer shaft links are set at a neutral position, as seen from above.
-
Tighten the stabilizer shaft link nut (1) to 29 Nm (21.0 ft. lbs.).
