Tracker 4WD L4-1.6L VIN 6 (1998)
1. Install the inboard anti-noise shim (9) on the caliper (13) (if removed).
2. Install the caliper assembly (1) to the vehicle.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
3. Secure the assembly with two caliper pin bolts (2).
^
Tighten the caliper pin bolts to 27 Nm (20 ft. lbs.).
4. Install the brake hose union bolt with two new union fitting washers.
^
Tighten the brake hose union bolt to 23 Nm (17 ft. lbs.).
5. Install the tire and wheel assembly.
6. Lower the vehicle.
7. Fill the master cylinder fluid reservoir.
8. Bleed the brake system.
Brake Caliper Overhaul
DISASSEMBLY PROCEDURE
CAUTION: Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could result in
