Tracker 4WD L4-1.6L VIN 6 (1998)
3. Remove the pipe guide clamps (2).
4. Disconnect the pipe(s) (1 ) to be replaced at each fitting.
5. Remove the pipe(s) from the vehicle.
INSTALLATION PROCEDURE
1. Install the brake pipe(s) (1) to the vehicle. Secure the pipe(s) at the respective guide clamps (2) and pipe fitting nuts.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
