Tracker 4WD L4-1.6L VIN 6 (1998)
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Install the pipe guide clamps.
^
Tighten the brake pipe fitting nuts to 16 Nm (12 ft. lbs.).
3. Flush and bleed the brake system.
Rear Brake Hose Replacement (W/O ABS)
REMOVAL PROCEDURE
1. Raise the vehicle. Support the vehicle.
2. Clean dirt and foreign material from the hose and fittings.
3. Remove the E-clips from the rear brake hose guide brackets.
4. Remove the brake hose (1) at the pipe fittings.
INSTALLATION PROCEDURE
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
1. Install the brake hose (1) to the pipe fittings. Secure the brake hose with pipe fitting nuts.
^
Tighten the brake pipe fitting nuts to 16 Nm (12 ft. lbs.).
2. Install the rear brake hose to guide brackets. Secure the hose with three E-clips.
3. Lower the vehicle.
4. Flush and bleed the brake system.
