Tracker 4WD L4-1.6L VIN 6 (1998)
1. Install the new reservoir grommets (3) into the master cylinder (4). Lubricate the grommets with new, clean brake fluid. Make sure the grommets
are seated properly.
2. Install the reservoir (1) to the master cylinder.
3. Install the reservoir roll pin (1) using a hammer and a punch.
4. Connect the fluid level switch electrical connector.
5. Refill the reservoir with brake fluid or equivalent.
6. Check for fluid leakage.
7. Connect the negative battery cable.
8. Bleed the brake system.