Tracker 4WD L4-1.6L VIN 6 (1998)
2. Install the master cylinder (2) and the new gasket to the vacuum booster. Secure with two mounting nuts and washers.
^
Tighten the master cylinder nuts to 13 Nm (115.1 inch lbs.).
3. Connect the fluid level switch electrical connector.
4. Connect the brake pipes to the master cylinder. Secure with the flare nuts.
^
Tighten the brake pipe flare nuts to 16 Nm (12 ft. lbs.).
5. On models with ABS, install the three-way joint (2) to the master cylinder. Secure the joint with one bolt.
6. Connect the negative batted cable.
7. Bleed the brake system.
