Tracker 4WD L4-1.6L VIN 6 (1998)
3. Install the LSPV load sensing spring bracket to the rear suspension upper arm. Secure with two bolts (1).
^
Tighten the load sensing spring bracket bolts to 23 Nm (17 ft. lbs.).
4. Install the LSPV assembly to the vehicle frame. Secure with two bolts (1).
^
Tighten the LSPV assembly bolts to 23 Nm (17 ft. lbs.).
5. Install the three brake pipes to the LSPV assembly.
6. Bleed the brakes.
7. Lower the vehicle.
8. Connect the negative battery cable.
IMPORTANT: The following conditions must be met before proceeding with this repair:
-
The fuel tank must be full.
-
The vehicle must have the spare tire, tools, jack and jack handle installed.
-
The vehicle must be free from any other load.
-
The vehicle is on a level (horizontal) floor.
9. Adjust the LSPV lever as follows:
