Tracker 4WD L4-1.6L VIN 6 (1998)
-
Rotating the modulator gears will cause the following conditions:
-
The pistons on the ABS brake modulator will be positioned very close to the top of the modulator bore.
-
The brake bleeding procedure is simplified.
IMPORTANT: Use care when handling the motor pack. Replace the motor pack if the motor pack is dropped or damaged during handling.
4. Position the motor pack onto the modulator, aligning the three motor pack gears with the modulator gears.
5. Install motor pack to modulator Torx head screws.
^
Tighten the motor pack Torx head screws to 5 Nm (44 inch lbs.).
6. Install the gear cover onto the modulator with Torch head screws.
^
Tighten the Torch head screws to 4 Nm (36 inch lbs.).
7. Install the brake modulator assembly into the vehicle.
8. Perform the Motor Rehome Procedure.
9. Perform the Diagnostic System Check.
