Tracker 4WD L4-1.6L VIN 6 (1998)
4. Install the pushrod clevis (5) to the brake pedal and secure with the clevis pin and the cotter pin.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
5. Secure the booster assembly mounting nuts (2).
^
Tighten the booster assembly mounting nuts (2) to 13 Nm (115 in lbs).
6. Install the hose (8) to the booster assembly (1) and secure with the hose clamp.
7. Install the Master Cylinder (1).
