Tracker 4WD L4-1.6L VIN 6 (1998)
1. Position new hose clamps on the open ends of the following hoses before installing the hoses to the coolant intake pipe (5):
^
On the two bypass hoses (6).
^
On the radiator outlet hose #1 (8).
^
On the heater core inlet hose (4).
2. Install a new O-ring (7) to the coolant intake pipe (5).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the coolant intake pipe to the vehicle and secure the pipe with one bolt.
^
Tighten the coolant intake pipe bolt to 11 Nm (97 inch lbs.).
4. Install the following hoses to the coolant intake pipe (5):
^
The two bypass hoses (6).
^
The radiator outlet hose #1 (8).
^
The heater core inlet hose (4).
5. Position the hoses over the coolant intake pipe flares.
6. Secure with the four hose clamps.
7. Fill the radiator with an approved coolant.
