Tracker 4WD L4-1.6L VIN 6 (1998)
30. Install the timing belt cover to the engine. Secure the timing belt cover with one nut and eight bolts.
^
Tighten the timing belt cover nut and bolts to 10 Nm (89 inch lbs.).
31. Install the oil pressure sending unit wire conduit to the timing belt cover.
32. Install the crankshaft pulley (4) to the crankshaft. Secure the crankshaft pulley with five bolts (3).
^
Tighten the crankshaft pulley bolts to 16 Nm (12 ft. lbs.).
33. Install the radiator shroud to the radiator. Secure the radiator shroud with two bolts.
^
Tighten the upper shroud bolts to 11 Nm (97 inch lbs.).
34. Carefully reposition the A/C suction line and the brackets to the right side of the radiator core support (if equipped). Secure the ARC suction line
and the brackets with two bolts.
^
Tighten the A/C suction line and the bracket bolts to 10 Nm (89 inch lbs.).
35. Raise and support the vehicle.
36. Install the two lower radiator shroud bolts.
^
Tighten the lower shroud bolts to 11 Nm (97 inch lbs.).
37. Install the front skid plate to the undercarriage (if equipped). Secure the front skid plate with four bolts.
^
Tighten the front skid plate bolts to 55 Nm (40 ft. lbs.).
38. Lower the vehicle.
39. Install the coolant pump pulley and the cooling fan to the coolant pump. Secure the pulley and fan with four nuts.
^
Tighten the coolant fan nuts to 11 Nm (97 inch lbs.).
40. Install the generator/coolant pump drive belt to the pulleys.
41. Install the A/C compressor (if equipped) and/or power steering drive belt to pulleys.
42. Adjust the generator/coolant pump drive belt.
43. Adjust the A/C compressor (if equipped) and/or power steering drive belt.
44. Install a new exhaust manifold gasket (1) and the exhaust manifold (2) with the engine hanger to the cylinder head.
