Tracker 4WD L4-1.6L VIN 6 (1998)
Throttle Body: Service and Repair
Unit Repair
CAUTION: The Throttle Position (TP) sensor, fast idle air valve or other components containing rubber must not be cleaned in a solvent or parts bath.
A chemical reaction will occur that can cause the parts to swell, harden or distort.
Disassembly Procedure
Do not remove the fast idle air valve from the throttle body. The fast idle air valve is not serviceable. The fast idle air valve is calibrated at the factory
and is not adjustable.
1. Remove the two screws from the TP sensor to the throttle body.
2. Remove the TP sensor from the throttle body.
3. Clean the passages by blowing with compressed air. Do not use drills or wires, these may damage the passages.
4. Clean all of the metal parts thoroughly and blow dry with shop air.
5. Be sure that all fuel and air passages are free of dirt or burns.
Assembly Procedure
1. Install the TP sensor to throttle body.
2. Secure the TP sensor with two screws. Do not tighten fully.
3. Install throttle body.
