Tracker 4WD L4-1.6L VIN 6 (1998)
2. Install the three retaining nuts.
^
Tighten the retaining nuts to 11 Nm (97 inch lbs).
3. Connect the EBCM electrical connectors.
4. Install the Knee bolster.
5. Connect the Negative (-) Battery Cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
6. Perform the Diagnostic System Check
