Tracker 4WD L4-1.6L VIN 6 (1998)
Speedometer Module: Service and Repair
REMOVAL PROCEDURE
IMPORTANT: When replacing a speedometer or an odometer assembly, the law requires the odometer reading of the replacement unit to be set to
register the same mileage as the previous odometer. If the same mileage cannot be set, then the law requires that the following actions take place:
^
Set the replacement odometer to zero.
^
Install a label on the driver's side door frame showing the following information:
^
The previous odometer reading
^
The date of replacement
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the cluster assembly from the panel.
3. Remove the cluster lens (7) and bezel (6) assembly from the cluster housing (3) by releasing the 8 black plastic tabs.
4. Remove the 4 screws (2) and the speedometer from the cluster housing.
INSTALLATION PROCEDURE
