Tracker 4WD L4-1.6L VIN 6 (1998)
4 Door
Description
NOTICE: Refer to Fastener Notice in Service Precautions.
1. Install the front seat belt retractor mechanism to the vehicle. Secure the mechanism with one mounting bolt.
Tighten
Tighten the front seat belt guide loop anchor bolt to 45 N.m (33 lb. ft).
2. Install the A-pillar trim to the A-pillar.
3. Install the rear side door scuff plate to the vehicle with two screws.
4. Install the front side door scuff plate with three screws.
5. Install the front seat belt guide loop anchor bolt.
Tighten
Tighten the front seat belt guide loop anchor bolt to 45 N.m (33 lb. ft).
6. Install the front seat belt guide loop cover.
7. Install the front seat belt lower anchor bolt (2).
Tighten
Tighten the front seat belt lower anchor bolt (2) to 45 N.m (33 lb. ft).
8. Position the carpet into place.
