Tracker 4WD L4-1.6L VIN 6 (1998)
Seat Belt: Service and Repair
Rear Seat Belt Replacement
2 Door
CAUTION: The seat belt assembly and/or bracket assembly must be replaced as a unit only. Do not substitute parts for any reason, or
personal injury could result.
CAUTION: Replace belts, retractors, and hardware in use during all but a minor collision. Also, restraint systems should be replaced and
anchorages properly repaired if they were in areas damaged by collision, whether the belt was in use or not. If there is any question, replace the
belt system. Damage, whether visible or not, could result in serious personal injury in the event of an accident.
Description
1. Fold the rear seatback.
2. Pull the rear seat release handle and raise the rear seat.
3. Unclip the support rod from the bottom of the rear seat and support seat.
4. Lift the rear seatbelt lower anchor bolt cover and remove the anchor bolt (1).
5. Remove the two-door folding top. Refer to Roof in Body and Accessories.
6. Remove the garnish moldings. Refer to Roof in Body and Accessories.
Description
7. Remove the two screws and the rubber stopper from the rear seat belt retractor trim cover (3).
8. Remove the rear seat belt guide loop cover (1) and the anchor bolt.
9. Loosen the rear door opening weather strip.
