Tracker 4WD L4-1.6L VIN 6 (1998)
4 Door
CAUTION: The seat belt assembly and/or bracket assembly must be replaced as a unit only. Do not substitute parts for any reason, or
personal injury could result.
CAUTION: Replace belts, retractors, and hardware in use during all but a minor collision. Also, restraint systems should be replaced and
anchorages properly repaired if they were in areas damaged by collision, whether the belt was in use or not. If there is any question, replace the
belt system. Damage, whether visible or not, could result in serious personal injury in the event of an accident.
Description
1. Remove the rear seat back cushion cover. Refer to Seats in Body and Accessories.
2. Pull back the rear seat cushion cover (2) in order to expose the seat belt buckle anchor bolts (1).
3. Remove the rear seat belt buckle anchor bolt and remove the buckle from the rear seat.
2 Door
NOTICE: Refer to Fastener Notice in Service Precautions.
Description
1. Install the rear seat belt buckle to the rear seat. Secure with one anchor bolt (1).
Tighten
Tighten the rear seat belt buckle anchor bolt to 45 N.m (33 lb ft).
2. Install the rear seat cushion trim cover to the rear seat. Secure with six screws.
3. Connect the rubber bumpers to the seat. Secure each bumper with one screw.
4. Install the rear seat release handle. Secure the handle with one pin and clip.
5. Install the support rod to the rear seat. Secure the rod with one pin and clip.
