Tracker 4WD L4-1.6L VIN 6 (1998)
Pulley And Shaft Installation To Side Plate
1. Oil seal, pulley with shaft attached and side plate to power steering pump.
Rotor Snap Ring
2. Cam ring, rotor and snap ring to pump.
3. Vanes to the rotor.
4. New O-ring seal and rear pump cover to pump; secure with four bolts.
Important: After installing cover, check to make sure that shaft can be turned by hand.
Tighten Power steering pump rear cover/cam ring bolts to 24 Nm (17.5 ft. lbs.).
