Tracker 4WD L4-1.6L VIN 6 (1998)
3. Lower steering shaft to steering gear, aligning shaft flats at the coupling. Secure with pinch bolt.
4. Pitman arm to center link; secure with castle nut.
Tighten Center link-to-pitman arm castle nut to 55 Nm (40 ft. lbs.).
5. Cotter pin to center link.
6. Splash shield to left inner wheel well; secure with screws.
7. Engine skid plate, if equipped; secure with four bolts.
Tighten Engine skid plate bolts to 27 Nm (20 ft. lbs.).
8. Lower vehicle.
9. Unplug power steering fluid hoses.
10. Return hose to steering gear; secure with one hose clamp.
11. Pressure hose to steering gear; secure with one union bolt.
Tighten Power steering gear pressure hose union bolt to 40 Nm (29 ft. lbs.).
12. Add power steering fluid to reservoir and bleed power steering system. Refer to Checking and Adding Fluid and to Bleeding System.
